Cisco DNCS System Release 2.7 3.7 4.2 Design Guide

Page of 110
1-20 
Introducing DOCSIS 
4000358 Rev B 
DHCT Initialization 
Introduction 
This section describes how DOCSIS-capable DHCTs operating in Mixed 
DOCSIS/DAVIC mode obtain the IP addresses for their cable modems and DHCT 
CPEs during initialization. This section also addresses how these DHCTs 
communicate their DHCT CPE IP address to the DNCS. 
Obtain and Communicate IP Addresses 
When the DOCSIS-capable DHCT boots in DOCSIS or Mixed DOCSIS/DAVIC 
mode, the DHCP server assigns an IP address to the cable modem element and the 
DHCT CPE. 
After obtaining the IP addresses, the DHCT communicates the DHCT CPE IP 
address to the DNCS using DNCS UNConfig messages. The DNCS must send an 
acknowledgement of receiving the IP address to the DHCT. Otherwise, the DHCT 
continues to attempt to communicate the IP address to the DNCS until it receives an 
acknowledgement.  
The following table shows the communication exchange when IP addresses are 
delivered to DHCTs in DAVIC and DOCSIS or Mixed DOCSIS/DAVIC mode: 
 
Message 
DAVIC Mode 
DOCSIS or Mixed 
DOCSIS/DAVIC Mode 
UNConfigRequest 
The UNConfigRequest 
message is sent from the 
DHCT to the DNCS to 
request an IP address. 
The UNConfigRequest 
message is sent from the 
DHCT to the DNCS to 
report its IP address that 
was assigned by the 
DHCP server. 
UNConfigConfirm 
The UNConfigConfirm 
message is sent from the 
DNCS to the DHCT to 
deliver an IP address. 
The UNConfigConfirm 
message is sent from the 
DNCS to the DHCT to 
acknowledge receipt of the 
UNConfigRequest 
message. 
The DHCT communicates its IP address to the DNCS when the DHCT initializes (or 
boots) and when the IP address changes.