Cisco DNCS System Release 2.8 3.8 4.3 Installation Guide
Chapter 3 Phase Two - Test New Software
46
78-4003052-01 Rev G
Install the Application Platform Software Release
for OSM Downloads
After disassociating and removing the old software files in the OS List window,
complete the procedures in this section to install the application platform software
release onto the BFS.
DHCT types that use the OSM Download method require the VER file and two
DHCT types that use the OSM Download method require the VER file and two
software files to be loaded onto the BFS carousel before being downloaded to the
DHCTs in the network.
Example: For Explorer 2000s, you would need the following files:
Example: For Explorer 2000s, you would need the following files:
15423001pe2m_3109002.ver (sent out-of-band as a software TOC file)
15423001pe2m__0 (sent in-band)
15423001pe2m__1 (sent in-band)
Note: See the
ROM to Model Matrix (on page 107) for information on the ROM file
names.
Before You Begin
Use the DHCT Type, Revision, and Source File Matrix in the ROM to Model Matrix
(on page 107) to identify the source files needed to download software to the DHCT
population.
Important!
Important!
If a file is used by more than one DHCT type or DHCT revision, you only need to
add that file once.
Unnecessary files will slow the software download. Be careful to load only those
files currently required by your system. Refer to How Do I Manage the Files on
My System? (on page 2) for more information.