Cisco DNCS System Release 2.2 3.2 Installation Guide
Chapter 2 Phase One - Perform Pre-Upgrade Checks
32
78-4003052-01 Rev G
6 Type y and press Enter to start the installation.
Note: The installation should take less than 30 seconds.
7 Did a message appear indicating that the installation was successful?
If yes, go to step 8.
If no, contact Cisco Services.
8 Use the UNIX rm -rfi command to remove the following file and directory:
SAIresapp.tar (file)
SAIresapp (directory)
Example: Type rm –rfi SAI* and press Enter.
Result: A confirmation question message appears asking you to confirm the
Result: A confirmation question message appears asking you to confirm the
removal.
9 Type Yes and press Enter.
10 Are there additional tar files in the directory you need to install?
10 Are there additional tar files in the directory you need to install?
If yes, repeat steps 4 through 7 until you have installed all the necessary files.
If no, go to Install the OS Check Table (Optional) (on page 34).
Installing the Software from a CD
Complete the following steps to install the application platform software release
onto the DNCS.
Notes:
Notes:
System components do not have to be shut down to install the software.
This procedure assumes the install_pkg package installer is located in the
/usr/sbin/ directory.
1 Insert the CD into the CD-ROM drive on the DNCS. The system automatically
mounts the CD to /cdrom/cdrom0 within 30 seconds.
2 Type df -n and press Enter. A list of the mounted file systems appears. If /cdrom
displays in the output, then this confirms that the system correctly mounted the
CD.
3 From the xterm window where you are logged on as root, type
cd /cdrom/cdrom0 and press Enter.
4 Type /usr/sbin/install_pkg SAIresapp and press Enter.
Results:
The system lists the packages that will be installed.
A confirmation message appears asking you to confirm that you want to
proceed with the installation.
5 Type y and press Enter to start the installation.
Note: The installation should take less than 30 seconds.