Cisco DNCS System Release 2.7 3.7 4.2 Technical References
4011319 Rev C
7
Configure Unencrypted Transport Streams
4 Power on the PC and activate a ProComm or HyperTerminal window using the
following modem connection settings:
9600 baud
1 stop bit
No parity
8 data bits
No flow control
5 Press the Enter key. A QAM> prompt appears.
6 Type pidmode 1 and press Enter to enable passthru mode.
7 Repeat steps 1 through 6 for any additional QAMs.
8 Go to
6 Type pidmode 1 and press Enter to enable passthru mode.
7 Repeat steps 1 through 6 for any additional QAMs.
8 Go to
Setting Up Non-Cisco Digital Sources (on page 7).
Setting Up Non-Cisco Digital Sources
Complete these steps to set up a non-Cisco digital source.
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the System Provisioning tab.
3 Click Source. The Source List window opens.
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the System Provisioning tab.
3 Click Source. The Source List window opens.
4 Does the source already exist?
If yes, click once on the row containing the source, then go to step 10.
If no, go to step 5.