Cisco Cisco RF Gateway 1 Installation Guide
Steps to Take
4038589 Rev A
39
EIS Parameters
The following table describes the EIS parameters.
Parameter
Description
EIS Name
Identifies the EIS in the CA System.
TCP Port
Listening port number used by the RFGW-1 to establish TCP
connection with the EIS.
Note: The TCP listening port number must be unique and cannot be
used by an EMM Generator or a PSI Generator.
connection with the EIS.
Note: The TCP listening port number must be unique and cannot be
used by an EMM Generator or a PSI Generator.
EIS Port Selection The Ethernet port to use for communication with the EIS.
Overrule
Overrule
When the Cryptoperiod parameter is encapsulated into Scrambling.
CP Duration
When control groups are missing or inaccurate, this parameter can
be overruled.
be overruled.
EIS Type
The following EIS types are available.
General - Third party EIS
SA Specific EIS of ROSA NMS
Note: Only one SA EIS can be assigned to a RFGW-1.
Connection
Status
Status
Status of the connection to the EIS.
Peer IP
IP address of the EIS.
Changing EIS Parameters
Follow the instructions below to change EIS parameters.
1 Click the drop down box to select the parameter to change.
1 Click the drop down box to select the parameter to change.
Result: The Apply and Reset buttons are now active.
2 Click Apply to accept change and Reset to abort.