Cisco Compact Mini Amp Models 93191 & 93198 862 MHz with 42 54 MHz Split Installation Guide
593161 Rev F
Installing and Configuring the GainMaker System Amplifier
2-17
Installing the Housing
Overview
The following procedures detail how to install the GainMaker amplifier on a strand
(aerial) or in a pedestal.
(aerial) or in a pedestal.
Strand (Aerial) Installation
Follow these steps to install the housing on an (aerial) strand. The housing does not
need to be opened for strand installation.
need to be opened for strand installation.
1.
Loosen the strand clamp bolts.
2.
Lift the housing into proper position on the strand.
3.
Slip the strand clamps over the strand and finger-tighten the clamp bolts. This
allows additional movement of the housing as needed.
allows additional movement of the housing as needed.
4.
Move the housing as needed to install the coaxial cable and connectors. See
the diagram below for an example.
the diagram below for an example.
Signal Flow from Left to Right
T6655
Coax Out
Coax Out
Coax Out
Strand Clamps
Strand
Coax In
AUX
AUX
MAIN
MAIN
AUX
AUX
MAIN
MAIN
R
R
F
F
R
R
R
R
R
R
5
5
3
3
2
2
1
1
4
4
6
6
F
F
F
F
F
F
Signal Flow from Right to Left
T7279
Coax Out
Coax Out
Coax In
Strand Clamps
Strand
Coax Out
AUX
AUX
MAIN
MAIN
AUX
AUX
MAIN
MAIN
R
R
F
F
R
R
R
R
R
R
5
5
3
3
2
2
1
1
4
4
6
6
F
F
F
F
F
F
Note: Coax In may be switched with the Coax Out if you reverse the
amplifier module and feed the signal from right to left.
amplifier module and feed the signal from right to left.
Continued on next page