Cisco Cisco 1 GHz GainMaker Amplifier Data Sheet
© 2016 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 5 of 6
6. Reverse Gain and Noise Figure for station with 0 dB reverse input pad, 0 dB reverse output EQ, and 1 dB
output pad.
7. Reverse Operational Gain, Noise Figure, and Return Loss are specified without reverse switch option. If switch
is installed, reduce Gain by 0.5 dB, increase Noise Figure by 0.5 dB, and decrease Return Loss by 1 dB.
8. Composite Intermodulation Noise is a broadband noise-like distortion product associated with QAM loading.
9. Distortion performance at reference output levels and tilt. Consult Cisco Systems Engineering for CIN
calculation.
Table 6.
Environmental and Mechanical Specifications
Environmental
Operating Temperature Range
-40 -140°F (-40 - 60°C)
Mechanical
Housing Dimensions
17.3 in. L x 7.2 in. H x 7.8 in. D
439.4 mm L x 182.9 mm H x 198.1 mm D
Weight
● Housing with power supply
● Module
● Module
12 lbs, 5 oz. (5.6 kg)
5 lbs, 5 oz. (2.4 kg)
Ordering Information
The GainMaker Ordering Matrix provides ordering information for configured amplifier modules or stations.
This page contains ordering information for required and optional accessories not included as part of a configured
amplifier module or station. Consult your account representative or customer service representative for ordering
assistance.
The required accessories described in Table 7 must be ordered separately (not included in GainMaker Ordering
Matrix).
Table 7.
Required Accessories
Required Accessories
Part Number
Plug-in Pads (attenuators) - Available in 0.5 dB steps from 0 to 20.5 dB
● 1 required for forward input
● 1 required for AGC, if applicable
● 1 required for AGC, if applicable
*
● 4 required for reverse (3 input, 1 output)
*
To determine AGC pad value, subtract 34 dB from the design value main port RF
output level at the AGC pilot frequency
589693 (0 dB) sequentially through 589734 (20.5 dB)
Plug-in Forward Cable Equalizer - Available in 1.5 dB steps from 0 to 30 dB at
1002 MHz
1002 MHz
● 1 required for forward input
4007228 (0 dB)
sequentially through 4007248 (30 dB)
Plug-in Reverse Cable Equalizer
– Available in 1 dB steps from 0 to 12 dB at 40
MHz
● 1 required for reverse output - unless design value is 0 dB (0 dB EQ is provided)
712719 (0 dB) and 4036769 (1 dB) sequentially through
4036780 (12 dB)
4036780 (12 dB)
The optional accessories described in Table 8 may be ordered separately.