Cisco Cisco StadiumVision Mobile Installation Guide
© 2011 Cisco Systems, Inc. All rights reserved
Page 23 of 71
7. Position the DIMM above the slot. Align the notch on the bottom edge of the
DIMM with the key in the DIMM slot. (See label 2 in Figure 19.)
8. Insert the bottom edge of the DIMM into the slot. (See label 3 in Figure 19.)
9. When the DIMM is correctly positioned, push down firmly on the top edge of
the DIMM until the ejector tabs snap into place. (See label 4 in Figure 19.)
Installing an Additional Disk Drive
The Cisco ADE 2140 Series appliance comes with one hard disk drive installed.
The recommended configuration for the SV Director Server is two 147 GB hard
drives. Therefore, you will need to install an additional disk drive.
The recommended configuration for the SV Director Server is two 147 GB hard
drives. Therefore, you will need to install an additional disk drive.
Up to six drives can be installed. The hard drive bay is at the left side of the
chassis, underneath the DVD-ROM drive. The hard drive trays in the drive bay
are labeled 1, 3, and 5 on the left side of the bay and 0, 2, and 4 on the right side
of the bay.The drives need to be installed in a specific order; that is, drive 0 must
be installed before drive 1, drive 1 before drive 2, and so on.
chassis, underneath the DVD-ROM drive. The hard drive trays in the drive bay
are labeled 1, 3, and 5 on the left side of the bay and 0, 2, and 4 on the right side
of the bay.The drives need to be installed in a specific order; that is, drive 0 must
be installed before drive 1, drive 1 before drive 2, and so on.
Caution! If you install fewer than six hard drives, the empty bays must have
drive trays with baffles in them to maintain proper appliance cooling.
drive trays with baffles in them to maintain proper appliance cooling.
To install a hard drive into the appliance:
1. Inspect the new drive for any signs of damage.
3. Power down the appliance and all external devices. Disconnect the AC power
cord and all external cables.
4. Attach the antistatic wrist strap to your wrist and connect its cord to the ESD
socket on the top, left-hand side on the front of the chassis.
5. Select the drive bay where you want to install the drive.
Note: If fewer than six drives are installed, drive bay 0 must be used first, then
drive bay 1, and so forth. The drive tray numbers are shown in Figure 20.
drive bay 1, and so forth. The drive tray numbers are shown in Figure 20.
6. Remove the drive tray by pressing the blue button to open the lever and pull
the tray out. (See label 1 in Figure 20.)