Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual
© 2011-2013 Cisco Systems, Inc. All rights reserved.
Commands
The Dashboard drawers contain commands that can be sent by SV Director to
perform actions and display settings for devices in StadiumVision. There are three
categories of commands that are sent by SV Director: Switch commands, DMP
commands, and TV commands. Refer to
perform actions and display settings for devices in StadiumVision. There are three
categories of commands that are sent by SV Director: Switch commands, DMP
commands, and TV commands. Refer to
Table 2. Dashboard Command Categories
Command Category
Description
Switch Commands
Switch commands are IOS commands that perform actions and display information for the
StadiumVision switch. For example, to toggle PoE on a switch port, you can send the Power
Cycle DMP command to instruct Cisco StadiumVision Director to send the command to the
switch. The switch will send a command back that reboots the PoE to the switch port connected
to the DMP.
StadiumVision switch. For example, to toggle PoE on a switch port, you can send the Power
Cycle DMP command to instruct Cisco StadiumVision Director to send the command to the
switch. The switch will send a command back that reboots the PoE to the switch port connected
to the DMP.
DMP Commands
DMP commands perform actions and display information for DMPs. For example, to restart
flash on a DMP, you can send the Restart Flash command. This will instruct Cisco
StadiumVision Director to send an HTTP command to the DMP and to restart it.
flash on a DMP, you can send the Restart Flash command. This will instruct Cisco
StadiumVision Director to send an HTTP command to the DMP and to restart it.
TV Commands
TV commands perform actions and display information about TVs. For example, to turn a TV
on or off, you can send the TV On or TV Off command. Cisco StadiumVision Director will send
the command to the DMP and the DMP will in turn send an RS-232 command across the
RS-232 connection to tell the TV to turn on or off.
on or off, you can send the TV On or TV Off command. Cisco StadiumVision Director will send
the command to the DMP and the DMP will in turn send an RS-232 command across the
RS-232 connection to tell the TV to turn on or off.
and
components when switch commands, DMP commands, and TV commands are sent
by StadiumVision Director.
by StadiumVision Director.
Figure 21. Endpoint Control with Cisco StadiumVision Director Commands