Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual

Page of 4
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
 
How to Configure the Reboot DMP System Task 
From the Management Dashboard
Revised: May 16, 2016
Software Release: 3.0 and Later Releases
Quick Facts
This task note describes how to configure the periodic Reboot DMP Task to run the DMP or switch 
command automatically.
  •
To avoid unexpected behavior and maintain normal operation of your devices, it is highly 
recommended that you perform a soft reboot of all of the DMPs in your system regularly.
  •
The Reboot DMP Task applies globally to all DMPs. When the recommended reboot interval is 
different by DMP model, be sure to set the reboot task to meet the shortest time interval. 
For example, in releases prior to Release 4.0, a weekly reboot is recommended for all media players. 
However, in Release 4.1.0-419, a weekly reboot is recommended only for the Cisco DMP 4310G 
and SV-4K—rebooting the DMP-2K is recommended every 5 days. Therefore, if using the reboot 
task in a venue that uses DMP-2Ks, the reboot period should be configured for 120 hours.
For information about recommended media player maintenance for your release, see the 
 documentation.
  •
There are a few methods that you can use to reboot DMPs:
Note
Before you perform a reboot, be sure that there are not any active scripts running.
  –
Reboot DMPs manually from the Management Dashboard using the following command:
DMP and TV Controls > DMP Commands > Reboot Device
  –
Power cycle the DMP manually from the switch using the following command:
DMP and TV Controls > Switch Commands > Power Cycle DMP
  –
Enable a system task to run periodically to reboot DMPs after they have been running for a 
specified number of hours (default is 336). The default start time is 03:00 a.m.