Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual

Page of 4
How to Deploy  WiFi Network Connectivity 
on the SV-4K
Dynamic Signage Director 
Software Release: 5.0.0-123 and Later Releases
First Published: 2016-10-10
Last Updated: 2016-11-30
Contents
 
 
 
 
Introduction
WiFi network support is useful when you need to deploy SV-4Ks in areas where there is no existing Ethernet cabling, 
where it is difficult to run cabling, or simply as an alternative to Ethernet network connectivity.
Note:
 For initial deployment of an SV-4K with WiFi connectivity, you will need both a POE+ network connection in 
addition to connection of the SV-4K using the DMP power supply adapter. After the DMP is deployed for WiFi, a POE+ 
connection is no longer needed for the DMP. In fact, the DMP will not route packets over the WiFi connection while 
the Ethernet port is connected and operational.
Support for wireless network connectivity to the SV-4K is available over an 802.11a, 802.11b, or 802.11n wireless 
network in the Cisco Vision Dynamic Signage Director venue beginning in Release 5.0. 
The wireless network SSID and passphrase is configured globally for all SV-4Ks in the system. The SV-4K firmware 
automatically tries to connect with WEP (if the passphrase is of a suitable length), WPA1 or WPA2.
Requirements
 
The system is running Cisco Vision Dynamic Signage Director Release 5.0 or later.
 
A WiFi access point is set up and configured to receive multicast messages.
 
A POE+ connection is available for initial deployment of the SV-4K. 
 
An SV-4K power adapter is available.
Cisco Systems, Inc.
1