Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual
© 2012 Cisco Systems, Inc. All rights reserved.
Page 43 of 103
Chapter 3 DMP Deployment
This section describes how to deploy Cisco 4310G Digital Media Players (DMPs)
using Cisco StadiumVision Director. The workflow described includes the auto-
registration and provisioning of the DMP and how to map the DMP to a Location
within Cisco StadiumVision Director. This workflow gets the DMP to the state where
it is configured and running the correct firmware version, and ready to be assigned
to its appropriate Groups.
using Cisco StadiumVision Director. The workflow described includes the auto-
registration and provisioning of the DMP and how to map the DMP to a Location
within Cisco StadiumVision Director. This workflow gets the DMP to the state where
it is configured and running the correct firmware version, and ready to be assigned
to its appropriate Groups.
This section assumes that you are familiar with the Cisco StadiumVision Director
Management Dashboard and Control Panel. For further information on these parts
of the solution please refer to the Related Documents section at the beginning of
this guide.
Management Dashboard and Control Panel. For further information on these parts
of the solution please refer to the Related Documents section at the beginning of
this guide.
Installation Prerequisite Steps
1. Enable Auto-Registration and Provisioning in Cisco StadiumVision Director.
2. Configure the switch ports for DMP.
3. Configure a DHCP Server for DMP Auto Registration.
4. Set the Default Video Channel URL in Cisco StadiumVision Director.
5. In Cisco StadiumVision Director, create a Display Specification with
2. Configure the switch ports for DMP.
3. Configure a DHCP Server for DMP Auto Registration.
4. Set the Default Video Channel URL in Cisco StadiumVision Director.
5. In Cisco StadiumVision Director, create a Display Specification with
corresponding RS-232 codes, for each TV model being deployed.
6. Load the previously-defined TV/DMP Locations into Cisco StadiumVision
Director.
7. Assign each Location to its desired Groups.
Installation Steps and Flow
1. The installer mounts the TV and DMP in the desired spot.
2. The installer then connects the required power, video, audio, network and
2. The installer then connects the required power, video, audio, network and
control cabling.
3. The DMP powers up and gets network information via DHCP, including the
Cisco StadiumVision Director registration URL.
4. Next the DMP auto-registers with Cisco StadiumVision Director using the
registration URL. As a result the DMP appears in the Cisco StadiumVision
Director database in state “Not-Ready.”
Director database in state “Not-Ready.”
5. Cisco StadiumVision Director then proceeds to provision the DMP and
upgrade the firmware. Once complete the DMP state changes to “Ready.”
6. Before leaving the area the installer records the Location and corresponding
DMP MAC address.
7. The DMP MAC address and Location pairs are handed off to a data entry
person, who uses it to map each DMP to its target Location.