Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual

IMPORTANT: Before you power on the SV-4K device for the
first time, be sure that you have completed the following
configuration and tasks:

Switch configuration, including the required LLDP for
proper POE+ operation.

DHCP server configuration.

Uploaded the released firmware to Cisco StadiumVision
Director.

Configured the auto-registration settings for the SV-4K to
properly provision its firmware.

Obtaining the SV-4K Firmware

The SV-4K firmware image is not bundled with the Cisco StadiumVision Director
software. You must download the firmware image separately from the external vendor
site and then upload it to Cisco StadiumVision Director.

TIP: Be sure to download the firmware to a device that you also
can use to access the Cisco StadiumVision Director software.

For information about how to download the SV-4K firmware, see the “How to Download
SV-4K Firmware” document, available to qualified Cisco StadiumVision partners on
ciscoet.com.

Uploading the SV-4K Firmware From the Management
Dashboard

After you have obtained the SV-4K firmware image from the external vendor, you must
upload the image to Cisco StadiumVision Director.

To upload the SV-4K firmware, complete the following steps:

1. From the device where you downloaded the SV-4K firmware, log into Cisco

StadiumVision Director as an administrator.

2. Go to the Management Dashboard.

3. Go to DMP and TV Controls > DMP Install > Firmware Upgrade.

29 of 68