Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual

Page of 103
 
 
© 2011 Cisco Systems, Inc. All rights reserved.   
 
Page 53 of 103 
Enabling Auto Registration and Auto-Provisioning 
By default, the auto-registration and auto-provisioning settings in Cisco 
StadiumVision Director are disabled. To use these features, you need to enable 
them in the Management Dashboard as follows. 
1.  Open the Management Dashboard and select Director Configuration > Auto 
Registration Settings
2.  In the Cisco StadiumVision Director Configuration Property panel, set the values 
to ‘true’ for Enable Auto Registration and Enable Auto Provisioning. Refer to 
. 
3.  Click the save button.  
Figure 41. 
Enabling Auto Registration and Auto Provisioning in the Dashboard 
 
Configuring the DMP Firmware Version 
As part of auto-registration Cisco StadiumVision Director will upgrade a DMP that is 
not already running the desired version. The desired version must be explicitly 
configured by setting init.version and init.build in the same window where auto-
registration/provisioning was enabled in the previous section. Both init.version and 
init.build have default settings. These may or may not match the desired version for 
a given deployment, so they should be checked before DMP deployment starts so 
they can be modified if needed.  
The latest DMP 4310 firmware can be downloaded from SW-Center on 
In order to deploy it to DMPs the firmware must first be uploaded to 
CISCO STADIUMVISION DIRECTOR using the 
DMP_and_TV_Controls
àDMP_InstallàFirmwareàUpgrade option.