Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual

Page of 103
 
 
© 2011 Cisco Systems, Inc. All rights reserved.   
 
Page 62 of 103 
To configure RS-232 serial commands: 
1.  Open the Serial Commands tab: 
Figure 45. 
Serial Commands Screen 
 
2.  From the Available Serial Commands list, select the command or commands 
that you wish to add and click <<. This adds the command name to the list of 
Configured Serial Commands.  
3.  If the command you wish to configure is not in the list of Available Serial 
Commands, click the + at the upper right of the list box and enter the label you 
wish to use for the new command. Then click << to add the command to the list 
of Configured Serial Commands.  
4.  Highlight the serial command in the Configured Serial Commands list. 
5.  Click the + above the Serial Strings of Selected Commands list. 
6.  Enter the appropriate serial string. This string will now be associated with the 
highlighted serial command for this device. 
Defining External Volume Commands 
When using external volume control you must configure RS-232 commands to send 
to the TV when changing volume. Volume commands do not need to be configured 
when internal volume control is used. 
StadiumVision Director allows you to define volume controls that are relative 
(volume up and volume down) or absolute (volume number). Relative volume 
commands depend on the volume increments set in the TV, which may vary widely 
from model to model. Therefore, the preferred method is to use absolute volume 
controls.