Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual

Page of 40
 
 
© 2011 Cisco Systems, Inc. All rights reserved.
 
 
Page 37 of 40 
 
Managing Switch-to-DMP Connections 
The Switch Commands in the Device Configuration 
drawer help you manage switch-to-DMP connections. 
These commands operate on the selected DMP(s) but are 
executed on the Layer 2 switch to which the DMPs are 
connected. This is in contrast to the other Dashboard 
commands which are sent directly to the selected DMPs. 
 
 
Using the Switch commands on the Dashboard you can: 
  Identify a switch port and invoke a TDR test for that port to confirm the integrity of 
the port and cable.  
  Retrieve the status for a specific switch port and confirm the administrative and 
operational state. 
  Cycle PoE power on a specific switch port and reboot a DMP that is not 
responding.  
  Clear the ARP table for a specific IP address and restore connectivity to a DMP 
that was recently replaced.  
  Ping a DMP from the switch to which it is directly connected. This helps you to 
determine if there are any local connectivity issues. 
The Dashboard will attempt to process the Switch Commands only to those DMPs for 
which the Dashboard can determine a switch-to-DMP connection. If this connection 
cannot be determined, an error message displays on the Console tab in the Device 
Details panel. 
Switch CLI Commands 
When you send a switch command, the Dashboard uses the mapping information to 
send the CLI commands to the switch to which the selected DMP is connected.  
Table 5 the CLI commands sent by the Dashboard to the switch for each of the 
Switch Commands. In this example the DMP is connected to interface Gi2/17 on 
switch sjc_29_lab_gw1. 
DMP Name = Test_DMP 
DMP IP Address = 10.10.1.1 
Switch connection = sjc_29_lab_gw1 
Interface = Gi2/17,  
Note: The Dashboard uses Telnet protocol to connect to the switch with the supplied 
credentials.