Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual
© 2011 Cisco Systems, Inc. All rights reserved.
Page 11 of 94
DMP 4310G IR Remote
Figure 5.
Cisco 4310G DMP IR Remote
Table 2.
IR Remote Button Map
Port
Usage
Power Button
Turns power to the DMP 4310G on/off. This is a latching push button.
Reset Button
Resets the DMP to factory defaults.
HDMI Output Port
19-pin HDMI 1.1, supporting up to 1080 p, progressive and interlaced video
S-Video
Component and
Composite
Component and
Composite
7-pin S-Video port supports both S-Video and Component. The S-Video only
requires 4 pins. The Component requires 7 pins.
requires 4 pins. The Component requires 7 pins.
USB Ports
Connect to a USB device for additional ad or other storage. There is 32 GB
onboard storage for the DMP 4310G.
onboard storage for the DMP 4310G.
IR Extender
3.5 mm IR Receiver Extension. Connects to a USBIR Extender to extend IR
control. This is used in situations where the DMP is mounted behind the TV such
that the IR sensor is not visible.
control. This is used in situations where the DMP is mounted behind the TV such
that the IR sensor is not visible.
Unbalanced audio
connector
connector
3.5 mm stereo jack that provides an RS-232 audio connection.
RS-232 Port
3.5 mm jaco RS-232 serial connection for TV control.
Console Port
(debug)
(debug)
RJ-45 serial port for connecting to a console PC terminal. Cisco TAC use only
and requires a special cable. The port does not work like a Cisco IOS Router
console port.
and requires a special cable. The port does not work like a Cisco IOS Router
console port.
Ethernet Port
10/100/1000 RJ-45 10/100 BASE-T Ethernet port
Power Port
12V, 3 amp power input. Connects the DMP 4310G to power. Note that the
amperage rating for this port is different than the DMP 4305G power port. Do not
connect a DMP 4305G power supply to this port.
amperage rating for this port is different than the DMP 4305G power port. Do not
connect a DMP 4305G power supply to this port.