Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual
© 2011 Cisco Systems, Inc. All rights reserved.
Page 36 of 94
Auto Registration Workflow
1. Upon boot up, the DMP sends a DHCP DISCOVER message including the Option 60
information to identify itself as a DMP 4310 to the DHCP Server.
2. The DHCP server recognizes the identifier and sends back an OFFER including Option
43 information. This information is the URL that tells the DMP where to register. The
URL used for registering is as follows: http://
URL used for registering is as follows: http://
<SV Director IP
Address>
/StadiumVision/dmp_reg.
3. The DMP sends a registration to the URL and registers with SV Director. This takes
about 20 seconds. Figures 35 and 36 show DMPs that have successfully registered with
SV Director but are shown in the “Not Ready” state as they have not been provisioned.
SV Director but are shown in the “Not Ready” state as they have not been provisioned.
Figure 35.
Auto Registered DMPs in the Dashboard
Figure 36.
Auto Registered DMPs in the Control Panel
Understanding DMP Provisioning
The DMPs require specific configuration and firmware to be provisioned before the
DMP can be placed into production. This section will describe that workflow.
DMP can be placed into production. This section will describe that workflow.