Cisco Cisco StadiumVision Mobile Streamer Release Notes

Page of 46
 
 
© 2011 Cisco Systems, Inc. All rights reserved.  
26 of 26 
 
Figure 1. 
StadiumVision Confidence Monitor 
 
 
Notes: 
 
A DMP proxy can only be associated with one target DMP. However, a DMP can have more 
than one proxy associated with it.  
 
Once a DMP has been set as a proxy, it cannot be set as a target of another proxy. This avoids 
circular references.  
 
A DMP that is designated to be a proxy but has no associated target has no effect on that DMP’s 
operation. 
 
Confidence monitor will not correctly show a video playlist playing on the target DMP if that video 
file has not also been distrubited to the proxy DMP via VDM. 
 
Graphics that appear on the target MP as a result of local TV control will not be reflected on the 
confidence monitor. This includes, but is not limited to, channel guide, banners, commerce 
screens, etc. 
See the StadiumVision Event Operators Guide for more information. 
New Location for Ad Insertion Files 
Ad Insertion Manager (AIM) files have been moved from /root to /var/sv/aim. Installing Release 2.3 
will take care of copying the files to the new destination. However, you need to manually clean up the 
AIM files in /root to free up disk space. 
Cisco Discovery Protocol (CDP) for the DMP 4310 
As of DMP firmware build 1932, Cisco Discovery Protocol (CDP) has been added to the DMP. For 
serviceability, the addition of CDP provides DMP identification information (i.e., Platform, FW 
Version, Port ID) to the switch and the switch provides identification information (i.e., switch name, IP 
Address, port, VLAN, Location ID, Location URL) to the DMP. After the DMP is registered with SV 
Director, this switch information can be seen in the Dashboard under Settings > Network > 
Medianet Services
. This information aids in troubleshooting both from the network side and the 
DMP. 
See the 
 for more information. 
Bulk Administration Tool (BAT) Enhancements 
The Bulk Administration Tool (BAT) has been streamlined in Release 2.3. The purpose of BAT 
remains unchanged; it provides a method to do bulk entry of data into SV Director. This is