Cisco Cisco StadiumVision Mobile Streamer Release Notes

Cisco StadiumVision Director currently works with DMP 4310Gs and DMP 4305Gs 
that meets the requirements specified below.  

Table 5.  DMP Requirements 

DMP 4310G 

Firmware: SE1.0.3, Build 1138 or Build 1408 

DMP 4305G 

Firmware: 5.1.1; Kernel: Linux version 2.4.22 

For step-by-step instructions for installing DMPs, see the StadiumVision Video 
Endpoint (DMP) Design and Implementation Guide. 

Upgrading DMP 4305Gs 

When using Cisco StadiumVision Director 2.x with DMP 4305Gs, ensure that you 
do the following (in order) via the StadiumVision Management Dashboard: 

•

  Apply the Initial Config 

•

  Upgrade the Kernel 

•

  Upgrade the Firmware 

•

  Upgrade the StadiumVision Daemon  

•

  Apply Global DMP settings (as needed) 

See the StadiumVision Video Endpoint (DMP) Design and Implementation Guide for 
more information. 

Downgrading DMP 4305Gs 

With newer DMP 4305Gs (for example, if new DMP 4305Gs are added to an 
existing deployment or a defective DMP 4305G is replaced with a newer one), the 
DMP may be shipped with a later version of firmware and the kernel than is 
supported by Cisco StadiumVision Director. In this case, the firmware and kernel 
need to be “downgraded” to enable communication between the DMP and Cisco 
StadiumVision Director. 

Because the Cisco StadiumVision Director cannot communicate with DMPs that 
have a later release of the firmware, you cannot use the Management Dashboard to 
load the correct firmware and kernel. Also, DMPDM release 5.2 no longer supports 
the set_param?init.ROOT_disable=0 command. Therefore, you can not ssh 
into the DMP using sysmng or root.