Cisco Cisco Prisma II EDR Receiver Installation Guide

 

Connecting the RF Cables to the Chassis 

 

23 

 

Complete the appropriate procedure below to connect RF cables for the module. 

Note: This procedure assumes that the chassis is mounted in a rack. 

Note: This procedure assumes a host module with receivers in both lower and upper 
half-slot positions. If only one receiver installed, it is not necessary to connect RF 
cables for the unused position. 
1  Locate the RF ports on the chassis connector panel. The connector panel is on the 

front of a front-access chassis, and on the rear of a rear-access chassis. The figure 
below shows the connector panel for a rear-access chassis. 

 

2  Connect RF cables to the Port A and Port C connectors for the chassis slot in 

which the host module will be installed. These are the RF output connections for 
the module in the lower half-slot position. Hand-tighten the connectors. 

 

3  Route the RF cables from Ports A and C (for the lower half-slot module) to the 

appropriate RF destinations.