Cisco Cisco Prisma II EDR Receiver Installation Guide

 

Chapter 2        Module Installation 

32 

 

 

      WARNING: 

Unterminated fiber cables and connectors may emit invisible laser radiation. 
Avoid direct exposure to the laser light source. Ensure that the fiber cable is 
terminated before "fishing." 

The Fiber Fish tool that was shipped with the Prisma II Chassis is used to pull an 
optical cable from the rear of the chassis to the front of the chassis so the optical 
cables can be connected to optical connectors on the front panel of the modules. 

 

 

At the end of the Fiber Fish tool is a small hook that allows you to hold an optical 
cable so that you can pull it through to the front panel of the chassis. 

 

 

To Pull the Optical Cable to the Module 
1  Insert the Fiber Fish tool through the slot located just above the bottom of the 

chassis. 

2  At the rear of the chassis, locate the appropriate optical cable. 
3  Insert the optical cable into the notched area of the Fiber Fish tool as shown 

below. 

 

4  At the front of the chassis, pull the Fiber Fish tool (with cable attached) to the 

front of the chassis. 

5  Disengage the optical cable from the Fiber Fish tool and attach to the appropriate