Cisco Prisma II Redundancy Interface Panel Data Sheet

 

 
 

In many cable systems today, transmitters, 
amplifiers, and receivers can be configured in 
a redundant mode.  There will be “Main” 
modules and “Backup” modules. In the Prisma 
II



 Platform, these modules are configured as 

Master / Slave.  This Master / Slave 
configuration requires a physical “pin-to-pin” 
connection from the Master module to the 
Slave module.  If a Prisma II Redundancy Interface Panel is not used, the pin-to-pin connections must be made at 
an external DB-37 connector/cable tied to the Prisma II Chassis. 
 
The Prisma

 

II Redundancy Interface Panel is a rack mount interface designed to make that external pin-to-pin 

connection for Master / Slave functionality in Prisma II Modules much easier to implement.  Once the Prisma

 

II 

Redundancy Interface Panel is connected to a Prisma II Chassis, Master/Slave can be easily connected using lever 
operated terminals on the front of the Prisma

 

II Redundancy Interface Panel. 

 
 

•  Designed for operation with the Prisma II Platform 

•  Provides the technician easier configuration setup to run Master/Slave for all Prisma II Modules 

•  Slot identification makes wiring fast and easy 

•  Connects to the Prisma II Chassis with DB-37 cables (cables included) 

•  Lightweight 1RU rack mount 

•  Lever operated terminals for simple wire connectivity 
 
 

