Cisco Prisma II 1310 nm HDTx Transmitters Installation Guide
Chapter 3 Operation using ICIM
60
SNMP Configuration
The IP Setup menu item in the ICIM menu allows you to enter an IP address, IP
subnet, and Gateway IP in order to configure the ICIM for remote status monitoring
and control by an SNMP network management system.
subnet, and Gateway IP in order to configure the ICIM for remote status monitoring
and control by an SNMP network management system.
This section does not describe how to implement SNMP. Refer to your SNMP
manager documentation or MIB information for instructions on implementing
SNMP, Version 1.
manager documentation or MIB information for instructions on implementing
SNMP, Version 1.
All of this configuration is also available through the Boot Dialog. The Boot Dialog
also allows community names and the default port number for traps to be changed.
also allows community names and the default port number for traps to be changed.
Note: Contact Cisco Services for MIB files.
SNMP Considerations
The following items should be considered when implementing SNMP.
The SNMP connection is made through the Ethernet port on the front of the
ICIM. (Use 10baseT cable with an RJ-45 connector.) To meet the requirements of
GR-1089-CORE, a shielded cable must be used and both ends must be grounded.
ICIM. (Use 10baseT cable with an RJ-45 connector.) To meet the requirements of
GR-1089-CORE, a shielded cable must be used and both ends must be grounded.
The network management system (NMS) must be installed behind a firewall to
prevent any ill-intentioned persons with an SNMP manager from accessing and
tampering with the ICIM.
prevent any ill-intentioned persons with an SNMP manager from accessing and
tampering with the ICIM.
When the ICIM has to handle excessive SNMP traffic, it will respond slowly to
both SNMP control and front panel input. If this occurs, reduce the update rate
of the SNMP manager.
both SNMP control and front panel input. If this occurs, reduce the update rate
of the SNMP manager.
Basic SNMP Setup
Refer to your SNMP manager documentation or MIB information for instructions on
implementing SNMP. Before you can use and reconfigure SNMP services, you need
to know the community strings in your network and the IP addresses or computer
names for SNMP management hosts to which traps are sent.
implementing SNMP. Before you can use and reconfigure SNMP services, you need
to know the community strings in your network and the IP addresses or computer
names for SNMP management hosts to which traps are sent.
To Set up the IP Configuration Parameters for SNMP Support using ICIM
1 Press the
ICIM
key.
Result: The ICIM menu appears.
2 Select the Password menu and enter the User Password.
Result: The ICIM allows configuration changes for the next 10 minutes.
Note: Refer to your specific hardware Installation and Operation Guide for more
information on using, entering, or changing the ICIM user password.
Note: Refer to your specific hardware Installation and Operation Guide for more
information on using, entering, or changing the ICIM user password.