Cisco Prisma II 1310 nm HDTx Transmitters Installation Guide
Chapter 1 Module Introduction
10
78-4021716-01 Rev C
Configuration Summary
Using any of the above methods, you can:
Enable or disable transmitter operation
Normal or CwMode
Enable or disable the “RF input low” alarm
Configure the module as master or slave
Set the relative RF drive level into the transmitter
Return to the factory default settings (except LCI)
Turns automatic gain control (AGC) on or off
Adjust the offset of optical modulation index (OMI) level
For detailed information on configuring this module, refer to Operation using ICIM