Cisco Prisma II 1310 nm HDTx Transmitters Installation Guide
Chapter 2 Module Installation
26
78-4021716-01 Rev C
To Connect Optical Cables to Module
Note: This procedure assumes that the chassis is mounted in a rack.
Important: Observe laser safety precautions. Refer to the Laser Safety information
Important: Observe laser safety precautions. Refer to the Laser Safety information
earlier in this guide.
Complete the following steps for each optical cable to be connected to the module.
1 Attach one end of the optical cable to the optical output connector located on the
Complete the following steps for each optical cable to be connected to the module.
1 Attach one end of the optical cable to the optical output connector located on the
front of the module.
2 Route the other end of the optical cable to the appropriate destination.