Cisco Cisco Prisma II EDR Receiver Installation Guide

 

OL-32414-01 

19 

 

Before you begin, make certain that your installation site meets the requirements 
discussed in this section. 

 

 

  

WARNING: 

Use this product in locations that restrict access to all persons who are not 
authorized.  Otherwise, personal injury or equipment damage may occur. 

Ensure that only authorized personnel have access to this equipment. Otherwise, 
personal injury or equipment damage may occur. 

 

To install this module, your site must be equipped with an Electronics Industry 
Association (EIA) equipment rack that properly houses the chassis with proper 
spacing for air circulation. For instructions on installing the chassis in the rack, refer 
to the guide that was shipped with the chassis. 

 

 

  

CAUTION: 

Avoid damage to this product! Operating this product outside the specified 
operating temperature limits voids the warranty. 

Follow these recommendations to maintain an acceptable operating temperature of 
the equipment. 

 

The temperature of the module must be maintained between 0



C and 50



C (32



F 

and 122



F). 

 

Keep cooling vents clear and free of obstructions. 

 

Provide ventilation as needed using air-deflecting baffles, forced-air ventilation, 
or air outlets above enclosures, either alone or in combination. 

 

All Prisma II application modules receive their electrical power from the chassis. The 
modules may be installed with the chassis under power.