Cisco Cisco Prisma II EDR Receiver Installation Guide

 

30 

OL-32414-01 

 

 

Warning: 

 

Avoid personal injury! Use of controls, adjustments, or procedures other 
than those specified herein may result in hazardous radiation exposure. 

 

Avoid personal injury! The laser light source on this equipment (if a 
transmitter) or the fiber cables connected to this equipment emit invisible 
laser radiation.  

 

Avoid personal injury! Viewing the laser output (if a transmitter) or fiber 
cable with optical instruments (such as eye loupes, magnifiers, or 
microscopes) may pose an eye hazard. 

 

 

Do not apply power to this equipment if the fiber is unmated or unterminated. 

 

Do not stare into an unmated fiber or at any mirror-like surface that could reflect 
light emitted from an unterminated fiber. 

 

Use safety-approved optical fiber cable to maintain compliance with applicable 
laser safety requirements. 

Important: Ensure that no optical power is present prior to this procedure. 
1  Turn optical power off to the connector. 
2  Using an optical connector scope, inspect the connector for scratches, burns, or 

other signs of damage. 
Note:  If the connector is damaged, replace the jumper. 

3  If the connector requires cleaning, swipe it across the face of the appropriate 

ferrule cleaner several times. This will remove dust and some films. 
Note:  You may hear a slight "squeak" while cleaning the connector, indicating 
that it is clean. 

4  Inspect the connector again. If the connector requires further cleaning, clean it 

using 99% isopropyl alcohol and a lint-free wipe. 

5  Swipe the connector across the face of the appropriate ferrule cleaner several 

more times to remove any film left by the alcohol. 

6  Repeat all the steps above as needed until the connector is clean.