Cisco Cisco Prisma II EDR Receiver Installation Guide
Chapter 2 Module Installation
18
78-4025693-01 Rev D
---------------------
Unauthorized or improper use of this system may result in
administrative disciplinary action and civil or criminal penalties.
By continuing to use this system you indicate your awareness of and
consent to these terms and conditions of use. LOG OFF IMMEDIATELY
if you do not agree to the conditions stated in this warning.
login:
9 Log in using the default username Administrat0r and the default password
AdminPassw0rd. Note the 0 (zero) character in each string.
login: Administrat0r
Password: AdminPassw0rd
Successful login will return the following prompt:
Login of user "Administrat0r" successful
Proceed to CLI at the prompt
Welcome to the ICIM User Interface.
Copyright (c) Cisco Systems, Inc., 2005
Proceed to CLI at the shell prompt
shell>
10 At the shell> prompt, type cli, and then press Enter. The CLI> command prompt
appears.
11 Enter the module configuration commands as indicated above.
12 Type logout and then press Enter to exit the session.
13 Remove the serial cable. It is no longer required.
12 Type logout and then press Enter to exit the session.
13 Remove the serial cable. It is no longer required.
To Set Up a Telnet Session with the ICIM
1 Using a Category 5 Ethernet (Cat5) cable, connect the ICIM front panel Ethernet
1 Using a Category 5 Ethernet (Cat5) cable, connect the ICIM front panel Ethernet
port to your local network.
2 Open a command prompt window and verify connectivity by pinging the ICIM's
IP address. For example:
C:\> ping 172.18.50.100