Cisco Cisco Prisma II ICIM 2 Installation Guide
Chapter 3 Operation Using CLI
52
78-4025693-01 Rev D
A typical response to this command is shown in the sample craft operator dialog
below:
CLI> icim <Enter>
ICIM> show traps
IDX STATE IP Address
0 Enabled 172.18.50.41
1 Enabled 172.18.50.1
2 Enabled 172.18.50.6
3 Disabled 0.0.0.0
4 Disabled 0.0.0.0
SUCCESS!
ICIM>
Show Clock
Note that the show command supports access to the ICIM real time clock (RTC), as
Note that the show command supports access to the ICIM real time clock (RTC), as
follows:
ICIM> show clock exit
MM-DD-YYYY HH:mm:ss
11-15-2005 12:01:40
SUCCESS!
ICIM>
Set Command
The set command allows a single value to be set in the ICIM. The basic syntax is:
set argument value
Where argument is one of the values listed in the following table.
Value
Function
CLLI
Common Language Locator ID code for the ICIM
CLOCK
Date and Time as maintained by the ICIM
COMMREAD
SNMP Read Community string
COMMWRITE
SNMP Write Community string
COMMTRAP
SNMP Trap Community string
GATEWAY
IP address of the TCP/IP gateway, for packet routing
IP
TCP/IP address of the ICIM
STATUSMSG
Error or Status message
SUBNET
Subnet mask, such as 255.255.255.0
UPDATEID
Write-only; value of 1 causes ICIM to re-read ID of all modules
Some of these values (IP and GATEWAY, for example) result in changes to the ICIM
NVRAM, but do not take effect until the next reboot.