Cisco Cisco Prisma II ICIM 2 Installation Guide
1-6
Introduction
78-713378-01 Rev C
The Back Panel
Back Panel Connectors
Blind-mate connectors make it easy to install this module. The connector on the back
of the module mates with a connector on the inside of the chassis. The 110-pin
connector provides the following:
•
Electrical power input
•
Alarm communications
•
Status-monitoring connections
•
Communications and control connections
Power and Communications Connector
The power and communications connector on the back of the module mates with a
connector inside of the chassis, and supplies power from the chassis to the
transmitter. The 110-pin connector also routes alarm and status-monitoring
information from the receiver to the Prisma II Chassis.