Cisco Prisma II 1310 nm HDTx Transmitters Installation Guide

2-6 

Installation 

78-713378-01 Rev C 

Important: This procedure assumes the Prisma II Chassis is mounted in a rack. 
Follow this procedure to make the RF connections for each module to be installed. 

1. 

At the front/rear of the Prisma II Chassis, locate the RF ports.  

 

 

 
Note:  RF Ports are located on the front of front access chassis. 

2. 

Attach an RF cable to the Port A connector (RF output) of the corresponding 

slot where the module is to be installed. This is the RF output connection. 

                 

 

3. 

Route the RF cable from Port A to the appropriate RF destination. 

4. 

Connect another RF cable to Port B (RF output) of the slot where the module 

is installed. Hand-tighten the connector. 

5. 

Route the RF cable from Port B to the appropriate RF destination. 

6. 

If F-connectors are installed, use a 7/16-in. open-end wrench to secure both 

cables to the connectors at the chassis.