Cisco Cisco Prisma II ICIM 2 Installation Guide
2-6
Installation
78-748705-01 Rev C
Connect RF Cables to the Chassis
Introduction
The following instructions explain how to make the RF cable connections for the
processor.
Connecting the RF Cables
Follow these steps to connect the RF cables to the chassis.
1.
Locate the RF ports of the corresponding slot where the processor is to be
installed.
2.
Attach one 75-ohm RF cable to the Port A connector (RF output 1) of the
corresponding slot where the module is to be installed. This is the channel A
RF input connection.