Cisco Prisma II 1310 nm HDTx Transmitters Installation Guide
78-748705-01 Rev C
Operation Using LCI
4-9
Start LCI
Introduction
When you start the LCI software, it queries the devices (modules) located in the
chassis that is connected to your computer. After this query process (referred to as
the learn mode), the LCI software does the following for each device it finds.
•
•
Represents the device in the device tree of the main LCI window
•
Makes the polling information available so you can check and configure various
parameters
Important: Your computer must be connected to the chassis before you start the LCI
software. For instructions, refer to Connect the Computer to the Chassis earlier in
this chapter.
Starting the LCI Software
Follow these steps to start the software.
1.
Double-click the LCI icon on your Windows desktop.
Result: The LCI Main window opens and the LCI Detect Configuration
dialog box displays.
2.
Verify the communication port displayed in the COM Port box. This is the
port on your computer that the chassis is connected to.
To change the COM port, type the word “COM” and then the port number.
Example: To specify COM port 2, type COM2.
To change the COM port, type the word “COM” and then the port number.
Example: To specify COM port 2, type COM2.