Cisco Cisco Prisma II EDR Receiver Installation Guide
78-748705-01 Rev C
Installation
2-7
Connect RF Cables to the Chassis,
Continued
3.
Attach the other 75-ohm RF cable to the Port B connector (RF input 2) of the
corresponding slot where the processor is to be installed. This is the channel
B RF input connection.
4.
Route the RF cables to the appropriate RF sources.
5.
If F-connectors are installed, use a 7/16-in. open-end wrench to secure both
cables to the connectors at the chassis.
6.
Proceed to the next section, Install the Processor in the Chassis.