Cisco Cisco Prisma II EDR Receiver Installation Guide
78-748705-01 Rev C
Introduction
1-11
Processor Configuration
Introduction
The processor is shipped from the factory with operational parameters set to factory
defaults. However, you may choose to configure the operating parameters so that
they are best suited for your application.
Configuration and Monitoring Methods
The table below shows the methods that can be used to configure and monitor the
processor.
Method
Description
Prisma II ICIM
If an ICIM is installed in the chassis, it can be used to
configure and monitor Prisma II application modules within
its domain.
For instructions on operating this module using an ICIM, refer
For instructions on operating this module using an ICIM, refer
to Chapter 3, Operation Using the ICIM.
LCI software
LCI running on a locally connected PC can be used to
configure operating parameters of Prisma II modules.
For instructions on operating this module using LCI, refer to
For instructions on operating this module using LCI, refer to
Chapter 4, Operation Using LCI.
TNCS software
If an ICIM is installed, TNCS can be used to configure and
monitor all functions of the Prisma II modules.
For instructions on operating this module using TNCS, see the
For instructions on operating this module using TNCS, see the
manual that was shipped with the TNCS software, TNCS
Administrator Software User’s Guide, part number 730201.
Parameter Configuration
Using any of the methods described above, you can do the following:
•
•
Configure the module in master, slave, or independent mode
•
Enable or disable noise suppression
•
Enable or disable optical transmitter sub-module 1 (top)
•
Enable or disable optical transmitter sub-module 2 (bottom)
•
Set the amount of RF attenuation for channel A
•
Set the amount of RF attenuation for channel B