Cisco Cisco Videoscape Voyager Vantage 3.0 Installation Guide
Chapter 4 Phase Three - Install New Software
50
OL-26412-01
Phase Three Completion Check
The instructions in this section provide the steps to ensure that you have successfully
completed the procedures for phase three of the installation process.
completed the procedures for phase three of the installation process.
Verifying Phase Three Installation
Complete the following steps to verify that you have successfully completed the
procedures for phase three of the installation process.
1 Open an xterm window on the DNCS.
2 Type listCVT -b and press Enter. The output displays a list similar to the
procedures for phase three of the installation process.
1 Open an xterm window on the DNCS.
2 Type listCVT -b and press Enter. The output displays a list similar to the
following data.
Example:
Example:
Important: You must correct each DHCT type that is not associated with an
image.
image.
3 After you have confirmed that all of the devices in your network have been
associated to an image, go to Phase Four - Verification (on page 51).