Cisco Cisco OptoStar II Driver Amplifier Installation Guide
Operating using ICIM LCD, Continued
•
To setup the channel load:
1. Press SET button to start the configuration;
2. Press ▲▼ buttons to change the analog channel number to its actual value,
2. Press ▲▼ buttons to change the analog channel number to its actual value,
and press SET button to confirm;
3. Press ▼ button to move the cursor in the QAM channel number setup field;
4. Press SET button to start the configuration;
5. Press ▲▼ buttons to change the QAM channel number to its actual value,
4. Press SET button to start the configuration;
5. Press ▲▼ buttons to change the QAM channel number to its actual value,
and press SET button to confirm;
6. Press ▼ button to move the cursor to the delta level setup field;
7. Press SET button to start the configuration;
8. Press ▲▼ buttons to change the delta level to its actual value, and press SET
7. Press SET button to start the configuration;
8. Press ▲▼ buttons to change the delta level to its actual value, and press SET
button to confirm;
9. Press ► button to move the cursor to “Set”;
10. Press SET button to save the configuration.
10. Press SET button to save the configuration.
Continued on next page
3-14 Operation
OL-29668-02