Cisco Cisco OptoStar II Driver Amplifier Installation Guide

Page of 71
Connections 
Fiber Connections 
Although the modules may be hot-swapped when service must be restored, it is 
recommended that the chassis and modules are installed prior to powering up the 
chassis. 
It is also recommended to connect fibers to the front panel before powering up 
the system. If fibers must be removed, it is recommended to disconnect power 
prior to removal to minimize possible exposure to laser radiation.
 
  CAUTION: 
Use only SC/APC terminated fiber to connect to modules. Clean the 
connector using recognized industry practices before connecting to any 
module to prevent performance degradation. 
For fiber cleaning information, see Care and Cleaning of Optical Connectors 
(page 2-8). 
See the illustration below for fiber connections. 
 
RF Cable Connections 
Use RF Connector for RF Connections 
Use a cable with F-type male RF connector (3/8-32 UNEF thread) to connect the 
RF output ports on the rear panel of the module. See the illustration below for RF 
cable connections. 
 
Continued on next page 
2-6 
Installation 
OL-29663-03 
downloadlike
ArtboardArtboardArtboard