Cisco Cisco OptoStar II Driver Amplifier Installation Guide
Connections, Continued
Use OptoStar II 4 in 1 Combiner Module for RF Connections
Use the OptoStar II 4 in 1 combiner module to change the 4-way reverse receiver
to a module with the working mode of four input signals and one output signal.
to a module with the working mode of four input signals and one output signal.
1. Select the reverse receiver module to install the 4 in 1 combiner module.
2. Hold the 4 in 1 combiner module vertically, with its four ports aligned with
2. Hold the 4 in 1 combiner module vertically, with its four ports aligned with
the four ports on the rear panel of the reverse receiver module.
3. Slide the 4 in 1 combiner module in smoothly until it seats completely.
Note: Check alignment if you feel significant resistance; do not press hard,
otherwise connector may be damaged.
otherwise connector may be damaged.
4. Tighten the mounting screws of the 4 in 1 combiner module by hand or
screwdriver, to secure the combiner module on the rear panel of the reverse
receiver module.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
receiver module.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
5. Repeat the steps above if more 4 in 1 combiner modules need to be installed.
6. Connect the RF cables.
See the illustration below for connections.
6. Connect the RF cables.
See the illustration below for connections.
OL-29663-03
Installation
2-7