Cisco Cisco OptoStar II Driver Amplifier Installation Guide

Page of 71
Operating using NMS Software, Continued 
Setup Parameters 
The table below lists the setup parameters of the OptoStar II reverse receiver 
module. 
Setup 
Parameters 
Description 
Factory Default 
Parameters for Each Module 
Gain Control 
Mode 
Shows/sets AGC or MGC gain 
control mode 
AGC mode for all 
four modules 
Shows/sets gain (In AGC mode the 
field is grayed out; In MGC mode the 
function is available: gain range -20 
to 0 dB, turn-off at -30 dB, with 1 dB 
step) 
0 dB (In AGC mode) 
Comment 
Comment 
You may add applicable comments 
as required. 
None 
 
 
 
 
3-28 
 
Operation 
OL-29663-03