Cisco Cisco OptoStar II 1550nm EDFA Installation Guide
Operating using ICIM LCD, Continued
Sub-menu 3 -- Reverse Receiver Module 3 Information
The illustration below shows sub-menu 3 of the OptoStar II reverse receiver
module - Reverse Receiver Module 3
module - Reverse Receiver Module 3
Information
.
By default, the gain control mode is set to AGC, and the cursor stays on the
selection field of AGC/MGC. Press ▲▼ button to select the gain control mode.
The optical input power of module 3 is also displayed in this sub-menu.
See Sub-menu 1 -- Reverse Receiver Module 1 (on page 3-8) for detailed operation
procedures.
selection field of AGC/MGC. Press ▲▼ button to select the gain control mode.
The optical input power of module 3 is also displayed in this sub-menu.
See Sub-menu 1 -- Reverse Receiver Module 1 (on page 3-8) for detailed operation
procedures.
Continued on next page
3-10
Operation
OL-29663-03