Cisco Cisco Unified Operations Manager 8.0 Information Guide
2
Supported Devices and Interoperable Software Table for Cisco Unified Operations Manager 2.2
OL-19473-04
Software Supported by Operations Manager 2.2
Software Supported by Operations Manager 2.2
The following is a list of the software supported by and interoperable with Cisco Unified Operations
Manager 2.2. If required, ensure these versions are installed before installing or upgrading Operations
Manager 2.2 unless otherwise noted:
Manager 2.2. If required, ensure these versions are installed before installing or upgrading Operations
Manager 2.2 unless otherwise noted:
Caution
If you install updated Cisco software before upgrading to Operations Manager, ensure you choose the
same directory that the software resided so that no issues occur.
same directory that the software resided so that no issues occur.
•
Cisco Unified Service Monitor 2.2
•
Cisco Unified Provisioning Manager 1.3.1
•
Cisco Unified Service Statistics Manager 1.2 (upgrade after installing Operations Manager)
•
CiscoWorks (LMS 2.6) and Common Services 3.2
•
Cisco Secure Access Control Server (ACS) 3.2, 3.2.3, 3.3.2, 4.0, 4.2
•
Cisco Device Fault Manager 3.1
Ensure you use these versions if you are configuring the Device and Credentials Repository (DCR)
master and slave mode.
master and slave mode.
Note
DCR master and slave mode supports the DCR master with any LMS provided that the Common
Services version is equivalent to, or higher than, the Operations Manager slave Common
Services version.
Services version is equivalent to, or higher than, the Operations Manager slave Common
Services version.
•
McAfee Virus Scan Enterprise 8.0
•
VMWare ESX 3.5
The following software applications are required for Cisco Unified Operations Manager 2.2:
•
Adobe Flash Player 7.0, 8.0, or 9.0.
•
One of the following:
–
Windows Server 2003 with Service Pack (SP) 1 or SP 2, Standard and Enterprise Editions.
–
Windows Server 2003 R2.
•
ODBC Driver Manager 3.5.10 or later.
To verify the version of ODBC Driver Manager, from the Windows desktop, select Start > Settings
> Control Panel > Administrative Tools > Data Sources (ODBC). Select the About tab. If
necessary, install Microsoft Data Access Component (MDAC) 2.5 or later.
> Control Panel > Administrative Tools > Data Sources (ODBC). Select the About tab. If
necessary, install Microsoft Data Access Component (MDAC) 2.5 or later.
For additional information on server or client requirements for Operations Manager, see the
Installation Guide for Cisco Unified Operations Manager 2.2.
Installation Guide for Cisco Unified Operations Manager 2.2.
Coresident Guidelines
For information on coresident guidelines, see the
on Cisco.com.