Cisco Prisma IP E100 Series Packet Ring Access Platform Release Notes
Prisma IP Optical Transport Release Notes, Release 7.8.1
Overview
Introduction
This software release supports software on the Prisma IP
™
M-Series, C-Series, E100,
E200, E500, E500A, and ES520 platforms. This release note describes features in
Release 7.8.1 as well as resolved and outstanding issues.
Release 7.8.1 consists of the following:
•
Release 7.8.1 consists of the following:
•
R7.8.1 64-bit Element Management System (EMS) for 64-bit Windows
•
R7.8.0 Element Management System (EMS)
•
R7.8.0 Element Management System Command Line Interface (EMS-CLI)
•
R7.7.1 SYSCON and E-Series images
•
R7.7.0 M/C-Series Line and Switch Card images
Release 7.8.1 updates EMS, introduces a 64-bit version of the EMS that runs on 64-bit
Windows platforms, and introduces a new EMS-CLI application. These applications
work with the embedded images from Release 7.7.
Safe Operation for Software Controlling Optical Transmission Equipment
If this document discusses software, the software described is used to monitor
and/or control ours and other vendors’ electrical and optical equipment designed to
transmit video, voice, or data signals. Certain safety precautions should be observed
when operating equipment of this nature.
For equipment specific safety requirements, refer to the appropriate section of the
For equipment specific safety requirements, refer to the appropriate section of the
equipment documentation.
For safe operation of this software, refer to the following warnings.
For safe operation of this software, refer to the following warnings.
WARNINGS:
•
Ensure that all optical connections are complete or terminated before using
this equipment to remotely control a laser device. An optical or laser device
can pose a hazard to remotely located personnel when operated without their
knowledge.