Cisco Prisma FiberLinX Modules (CWDM) Data Sheet
CWDM Gigabit FiberLinX Modules
3
Specifications
Optical
Wavelength Spacing
20 nm
Tx Wavelength
nominal
± 6 nm
Tx optical output range
0 to +5 dBm
Rx optical input range
0 to -24 dBm
Electrical
Twisted Pair Data Port
IEEE 802.3 10Base-T/100Base-TX/1000 for data; RJ-45
connector; Half/Full-Duplex operation
connector; Half/Full-Duplex operation
Fiber Data Port
IEEE 802.3 1000Base-FX for data; SC connectors; Half/Full-
Duplex operation
Duplex operation
Twisted Pair Management Port
IEEE 802.3 10Base-T/100Base-TX/1000 for management;
RJ-45 connector; Half/Full-Duplex operation
RJ-45 connector; Half/Full-Duplex operation
Local Console Port
DB-9, RS-232 connector
Standards Compliance
IEEE 802.1Q VLAN, 802.1p and 802.3x Flow Control
Bandwidth Control
Dynamic bandwidth control (244 Kbps at 1 GHz line rate) via
GUI-based management software
GUI-based management software
Cut Through Latency
< 15 us for 2 Media Converters back-to-back, 64 byte frame
size, 100% line utilization, bidirectional traffic
size, 100% line utilization, bidirectional traffic
Prisma MIB
MIB-II (RFC 1213)
Transmission Dot 3 (RFC1643)
Link Status of Ports
Packets Transmitted
Alignment Errors
Port Type
Packets Received
Single Collision Frames
Fiber Type
Octets (bytes)
Transmitted
Multiple Collision Frames
SNMP Port (Host/Remote)
Octets (bytes) Received
SQE Test Errors
SNMP Agent IP Address (Host/Remote/Single)
Plus All Standard MIB II
Objects
Deferred Transmissions
Link Partner
Late Collisions
Traps (Cold Start, Warm Start, Link Up, Link Down,
Authentication Failure, Remote Unit Lost, Remote Unit Back
Online, Far End TX Link On and Far End TX Link Off)
Authentication Failure, Remote Unit Lost, Remote Unit Back
Online, Far End TX Link On and Far End TX Link Off)
Excessive
Collisions
User-Definable Name of Product
Carrier
Sense
Errors
User-Definable ID/Name of Each Port
Frame Too Long
Enable/Disable Ports
Internal MAC Transmit Errors
Enable/Disable FiberAlert*
Internal MAC Receive Errors
Set Duplex Mode for Fiber Ports
Set Auto-Negotiation/Speed for Twisted Pair Ports
Specify the management port
NOTE: Functions/features in blue are configurable via the software, all others listed can be monitored.
* FiberAlert is not available on single-strand fiber versions.