Cisco Prisma FiberLinX Modules (CWDM Gigabit) Installation Guide
November 2004
Prisma
®
DS3/E3/STS-1 Media Converter Module Installation
Instructions
Overview
Purpose
These installation instructions provide product information and instructions for
installing the Prisma
installing the Prisma
®
DS3/E3/STS-1 Media Converter module.
Introduction
The Prisma DS3/E3/STS-1 module is an SNMP-manageable module that converts
thin coax signals to single-mode or multi-mode fiber signals at a data rate of 45 Mbps
(DS3), 34 Mbps (E3), or 52 Mbps (STS-1).
thin coax signals to single-mode or multi-mode fiber signals at a data rate of 45 Mbps
(DS3), 34 Mbps (E3), or 52 Mbps (STS-1).
Qualified Personnel
Only appropriately qualified and trained personnel should install, operate, maintain,
and service this product.
and service this product.
WARNING:
Allow only qualified personnel to install, operate, maintain, and service this
product. Otherwise, personal injury or equipment damage may occur.
product. Otherwise, personal injury or equipment damage may occur.
Continued on next page