Cisco Prisma MediaCenter 2 & 8 Slot Chassis Installation Guide
14
Prisma DS3/E3/STS-1 Media Converter Module Installation Instructions
4008357 Rev B
Module Installation Instructions
Electrostatic Discharge Precautions
Electrostatic discharge (ESD) can cause damage to the plug-in Media Converter
modules that install into the chassis. Always observe the following precautions
when installing or handling an add-in module or any board assembly.
modules that install into the chassis. Always observe the following precautions
when installing or handling an add-in module or any board assembly.
1.
Do not remove the module from its protective packaging until you are ready
to install it.
to install it.
2.
Wear an ESD wrist grounding strap before handling any module or
component. If you do not have a wrist strap, maintain grounded contact with
the system unit throughout any procedure requiring ESD protection.
component. If you do not have a wrist strap, maintain grounded contact with
the system unit throughout any procedure requiring ESD protection.
WARNING:
Integrated circuits and fiber optic components are extremely susceptible
to electrostatic discharge damage. Do not handle these components
directly unless you are a qualified service technician and use tools and
techniques that conform to accepted industry practices.
to electrostatic discharge damage. Do not handle these components
directly unless you are a qualified service technician and use tools and
techniques that conform to accepted industry practices.
3.
Hold boards by the edges only; do not touch the electronic components or
gold connectors.
gold connectors.
4.
After removal, always place the boards on a grounded, static free surface,
ESD pad, or in a proper ESD bag. Do not slide the board over any surface.
ESD pad, or in a proper ESD bag. Do not slide the board over any surface.
Continued on next page