Cisco Prisma FiberLinX Modules (1310 1550 nm) Installation Guide
Prisma MediaCenter Unified
Management Agent (UMA)
Installation Instructions
Management Agent (UMA)
Installation Instructions
Overview
Introduction
This document provides an overview of the Unified Management Agent (UMA)
and lists the products that will support UMA. For users who already have
Prisma® FiberLinX modules, this document also identifies the system
requirements for upgrading to UMA and provides a brief overview of the
upgrade process.
and lists the products that will support UMA. For users who already have
Prisma® FiberLinX modules, this document also identifies the system
requirements for upgrading to UMA and provides a brief overview of the
upgrade process.
This document is intended for authorized service personnel who have experience
working with similar equipment. The service personnel should have appropriate
background and knowledge to complete the procedures described in this
document.
working with similar equipment. The service personnel should have appropriate
background and knowledge to complete the procedures described in this
document.
Safe Operation for Software Controlling Optical Transmission
Equipment
Equipment
If this manual discusses software, the software described is used to monitor
and/or control ours and other vendors’ electrical and optical equipment designed
to transmit video, voice, or data signals. Certain safety precautions must be
observed when operating equipment of this nature.
and/or control ours and other vendors’ electrical and optical equipment designed
to transmit video, voice, or data signals. Certain safety precautions must be
observed when operating equipment of this nature.
For equipment specific safety requirements, refer to the appropriate section of the
equipment documentation.
equipment documentation.
For safe operation of this software, refer to the following warnings.
WARNING:
Ensure that all optical connections are complete or terminated before
using this equipment to remotely control a laser device. An optical or laser
device can pose a hazard to remotely located personnel when operated
without their knowledge.
without their knowledge.
Allow only personnel trained in laser safety to operate this software.
Otherwise, injuries to personnel may occur.
Restrict access of this software to authorized personnel only.
Install this software in equipment that is located in a restricted access area.