Cisco Cisco Unified Communications System Release 6.1 Technical Manual
PCM Data/Audio Analysis Without Cisco Internal
Decode
Decode
Document ID: 115749
Contributed by Jacky Lee, Cisco TAC Engineer.
Jul 22, 2013
Jul 22, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Verify
Troubleshoot
Prerequisites
Requirements
Components Used
Configure
Verify
Troubleshoot
Introduction
This document describes how to replay Pulse Code Modulation (PCM) data/audio as soon as the capture is
complete, without the use of a PCM decoder.
complete, without the use of a PCM decoder.
Prerequisites
Requirements
This feature was developed for the Cisco Integrated Services Router Generation 2 (ISRG2) and the Cisco
VG350 Analog Voice Gateway platforms, which include:
VG350 Analog Voice Gateway platforms, which include:
2900 Series
•
3900 Series
•
3900e Series
•
VG350
•
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Configure
In this section, you are presented with the information to configure the features described in this document.
Note: Use the Command Lookup Tool (registered customers only) to obtain more information on the
commands used in this section.
commands used in this section.