Cisco Unified Contact Center Enterprise 11.0(1) Technical Manual

 

 

      

www.cisco.com

 

Cisco Unified SIP Proxy 9.0 on Virtual 
Machine Configuration 

First Published: September 10, 2015 

Introduction 

This page provides configuration information for Cisco Unified SIP Proxy (Unified SIP Proxy) 9.0 on a Virtual Machine in a 
Cisco Unified Contact Center Enterprise (Unified CCE) environment.  

The intended audience should be familiar with Cisco Collaboration products and be able to perform system-level 
configuration of Cisco Collaboration components and deployments.  

The configuration information is based primarily on system testing performed on Unified CCE during Cisco Collaboration 
Systems Release 11.0(1).  

This topic does not contain detailed step-by-step procedures. For detailed information about installing, configuring, and 
administering Unified CCE, Cisco Unified Customer Voice Portal (Unified CVP), Cisco Unified Communications Manager 
(Unified Communications Manager), Cisco Unified Communications Manager Session Management Edition (Unified CM 
SME), or Unified SIP Proxy refer to the respective product documentation. 

Design

 

 

For information on design considerations and guidelines for deploying Unified SIP Proxy on a Virtual Machine in a Unified 
CCE environment:  

  

Topologies  

This section provides information about Unified SIP Proxy (CUSP) on a Virtual Machine in a Unified CCE environment.  

For information on specific deployments and sites where CUSP testing was performed, see 

.